Introduction
- Interface description
Ardupilot
Pixhawk Wiring Quick Start
Install Mission Planner
Loading Firmware
Connect Mission Planner to AutoPilot
Frame Class and Type Configuration
Compass Calibration
Accelerometer Calibration
Compatible RC Transmitter and Receiver Systems
Radio Control Calibration
How to calibrate 3DR Power Module
Ardupilot How to Connect ESCs and Motors
Pre-Arm Safety Check
Arming the motors
Upload wrong firmware-cubeblack
PX4 firmware with Qgroundcontrol
Config error:Unable to detect board type
Pixhawk2.4.8 for Rover
Compass calibrated problem
Electronic Speed Controller (ESC) Calibration
How to use Telemetry-XBee for PIXHAWK?
How to use Radio Telemetry For PIXHAWK flight controller?
How to use MiniOSD for pixhawk?
How to update bootloader for pixhawk with SD card?
How to update Bootloader for Pixhawk with JLINK SWD?
Published with GitBook

Connect buzzer and safety switch

Connect buzzer and safety switch

The buzzer and safety switch button are mandatory for Pixhawk. Connect to the BUZZER and SWITCH ports as shown.

results matching ""

No results matching ""